O-Lube | Zatkoff

O-LUBE is a barium base petroleum grease formulated to facilitate installation and extend service life of synthetic rubber seals.

A film applied to the seal itself as well as surfaces over which the seal will travel is suggested for best results. O-Lube combines excellent surface adherence characteristics and lubricity with inherent water resistance. It is especially recommended for low pressure pneumatic systems as well as reciprocating and low speed oscillating or rotary applications. O-Lube is well suited for most sealing service within a -20°F to +180°F (-29°C to +149°C) temperature range. However, it is not recommended for use in systems having micronic filters or in contact with seals unsuited for petroleum oil service such as silicone, butyl or ethylene propylene rubber. If these conditions exist, use of Super-O-Lube® should be considered.

DO NOT USE IN SYSTEM WHERE PURE OXYGEN IS PRESENT – FIRE OR EXPLOSION MAY RESULT.

SUPER O-LUBE® is a silicone lubricant intended to complement O-Lube in that it can be used with virtually any rubber polymer. It can also be used over a wider temperature range and in most cases will provide better environmental protection to the elastomer.

It is recommended that Super O-Lube® be used sparingly as only a thin film is necessary for best results. It is useful with a wide variety of fluid media since it is quite inert. High pressure systems as well as vacuum uses are typical applications where this lubricant is beneficial. It is useful from -65°F to +400°F (-54°C to +204°C).

In addition, Super O-Lube® is non-toxic and non-irritating under normal conditions: it will not clog 30 micron filters, is usually moisture resistant and adheres with unusual tenacity.